Struct nix::net::if_::InterfaceFlags

pub struct InterfaceFlags { /* fields omitted */ }

Standard interface flags, used by getifaddrs

Implementations

impl InterfaceFlags

pub const IFF_UP: InterfaceFlags

Interface is running. (see netdevice(7))

pub const IFF_BROADCAST: InterfaceFlags

Valid broadcast address set. (see netdevice(7))

pub const IFF_DEBUG: InterfaceFlags

Internal debugging flag. (see netdevice(7))

pub const IFF_LOOPBACK: InterfaceFlags

Interface is a loopback interface. (see netdevice(7))

pub const IFF_POINTOPOINT: InterfaceFlags

Interface is a point-to-point link. (see netdevice(7))

pub const IFF_NOTRAILERS: InterfaceFlags

Avoid use of trailers. (see netdevice(7))

pub const IFF_RUNNING: InterfaceFlags

Resources allocated. (see netdevice(7))

pub const IFF_NOARP: InterfaceFlags

No arp protocol, L2 destination address not set. (see netdevice(7))

pub const IFF_PROMISC: InterfaceFlags

Interface is in promiscuous mode. (see netdevice(7))

pub const IFF_ALLMULTI: InterfaceFlags

Receive all multicast packets. (see netdevice(7))

pub const IFF_MASTER: InterfaceFlags

Master of a load balancing bundle. (see netdevice(7))

pub const IFF_SLAVE: InterfaceFlags

Slave of a load balancing bundle. (see netdevice(7))

pub const IFF_MULTICAST: InterfaceFlags

Supports multicast. (see netdevice(7))

pub const IFF_PORTSEL: InterfaceFlags

Is able to select media type via ifmap. (see netdevice(7))

pub const IFF_AUTOMEDIA: InterfaceFlags

Auto media selection active. (see netdevice(7))

pub const IFF_DYNAMIC: InterfaceFlags

The addresses are lost when the interface goes down. (see netdevice(7))

pub const IFF_LOWER_UP: InterfaceFlags

Driver signals L1 up. Volatile.

pub const IFF_DORMANT: InterfaceFlags

Driver signals dormant. Volatile.

pub const IFF_ECHO: InterfaceFlags

Echo sent packets. Volatile.

pub const IFF_NO_PI: InterfaceFlags

Do not provide packet information

pub const IFF_TUN: InterfaceFlags

TUN device (no Ethernet headers)

pub const IFF_TAP: InterfaceFlags

TAP device

pub const fn empty() -> InterfaceFlags

Returns an empty set of flags

pub const fn all() -> InterfaceFlags

Returns the set containing all flags.

pub const fn bits(&self) -> c_int

Returns the raw value of the flags currently stored.

pub fn from_bits(bits: c_int) -> Option<InterfaceFlags>

Convert from underlying bit representation, unless that representation contains bits that do not correspond to a flag.

pub const fn from_bits_truncate(bits: c_int) -> InterfaceFlags

Convert from underlying bit representation, dropping any bits that do not correspond to flags.

pub const unsafe fn from_bits_unchecked(bits: c_int) -> InterfaceFlags

Convert from underlying bit representation, preserving all bits (even those not corresponding to a defined flag).

pub const fn is_empty(&self) -> bool

Returns true if no flags are currently stored.

pub const fn is_all(&self) -> bool

Returns true if all flags are currently set.

pub const fn intersects(&self, other: InterfaceFlags) -> bool

Returns true if there are flags common to both self and other.

pub const fn contains(&self, other: InterfaceFlags) -> bool

Returns true all of the flags in other are contained within self.

pub fn insert(&mut self, other: InterfaceFlags)

Inserts the specified flags in-place.

pub fn remove(&mut self, other: InterfaceFlags)

Removes the specified flags in-place.

pub fn toggle(&mut self, other: InterfaceFlags)

Toggles the specified flags in-place.

pub fn set(&mut self, other: InterfaceFlags, value: bool)

Inserts or removes the specified flags depending on the passed value.

Trait Implementations

impl Binary for InterfaceFlags

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl BitAnd<InterfaceFlags> for InterfaceFlags

type Output = InterfaceFlags

The resulting type after applying the & operator.

fn bitand(self, other: InterfaceFlags) -> InterfaceFlags

Returns the intersection between the two sets of flags.

impl BitAndAssign<InterfaceFlags> for InterfaceFlags

fn bitand_assign(&mut self, other: InterfaceFlags)

Disables all flags disabled in the set.

impl BitOr<InterfaceFlags> for InterfaceFlags

type Output = InterfaceFlags

The resulting type after applying the | operator.

fn bitor(self, other: InterfaceFlags) -> InterfaceFlags

Returns the union of the two sets of flags.

impl BitOrAssign<InterfaceFlags> for InterfaceFlags

fn bitor_assign(&mut self, other: InterfaceFlags)

Adds the set of flags.

impl BitXor<InterfaceFlags> for InterfaceFlags

type Output = InterfaceFlags

The resulting type after applying the ^ operator.

fn bitxor(self, other: InterfaceFlags) -> InterfaceFlags

Returns the left flags, but with all the right flags toggled.

impl BitXorAssign<InterfaceFlags> for InterfaceFlags

fn bitxor_assign(&mut self, other: InterfaceFlags)

Toggles the set of flags.

impl Clone for InterfaceFlags

fn clone(&self) -> InterfaceFlags

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Copy for InterfaceFlags

impl Debug for InterfaceFlags

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Eq for InterfaceFlags

impl Extend<InterfaceFlags> for InterfaceFlags

fn extend<T: IntoIterator<Item = InterfaceFlags>>(&mut self, iterator: T)

Extends a collection with the contents of an iterator.

fn extend_one(&mut self, item: A)

🔬 This is a nightly-only experimental API. (extend_one)

Extends a collection with exactly one element.

fn extend_reserve(&mut self, additional: usize)

🔬 This is a nightly-only experimental API. (extend_one)

Reserves capacity in a collection for the given number of additional elements.

impl FromIterator<InterfaceFlags> for InterfaceFlags

fn from_iter<T: IntoIterator<Item = InterfaceFlags>>(
    iterator: T
) -> InterfaceFlags

Creates a value from an iterator.

impl Hash for InterfaceFlags

fn hash<__H: Hasher>(&self, state: &mut __H)

Feeds this value into the given Hasher.

fn hash_slice<H>(data: &[Self], state: &mut H) where
    H: Hasher, 

Feeds a slice of this type into the given Hasher.

impl LowerHex for InterfaceFlags

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Not for InterfaceFlags

type Output = InterfaceFlags

The resulting type after applying the ! operator.

fn not(self) -> InterfaceFlags

Returns the complement of this set of flags.

impl Octal for InterfaceFlags

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Ord for InterfaceFlags

fn cmp(&self, other: &InterfaceFlags) -> Ordering

This method returns an Ordering between self and other.

#[must_use]fn max(self, other: Self) -> Self

Compares and returns the maximum of two values.

#[must_use]fn min(self, other: Self) -> Self

Compares and returns the minimum of two values.

#[must_use]fn clamp(self, min: Self, max: Self) -> Self

🔬 This is a nightly-only experimental API. (clamp)

Restrict a value to a certain interval.

impl PartialEq<InterfaceFlags> for InterfaceFlags

fn eq(&self, other: &InterfaceFlags) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &InterfaceFlags) -> bool

This method tests for !=.

impl PartialOrd<InterfaceFlags> for InterfaceFlags

fn partial_cmp(&self, other: &InterfaceFlags) -> Option<Ordering>

This method returns an ordering between self and other values if one exists.

fn lt(&self, other: &InterfaceFlags) -> bool

This method tests less than (for self and other) and is used by the < operator.

fn le(&self, other: &InterfaceFlags) -> bool

This method tests less than or equal to (for self and other) and is used by the <= operator.

fn gt(&self, other: &InterfaceFlags) -> bool

This method tests greater than (for self and other) and is used by the > operator.

fn ge(&self, other: &InterfaceFlags) -> bool

This method tests greater than or equal to (for self and other) and is used by the >= operator.

impl StructuralEq for InterfaceFlags

impl StructuralPartialEq for InterfaceFlags

impl Sub<InterfaceFlags> for InterfaceFlags

type Output = InterfaceFlags

The resulting type after applying the - operator.

fn sub(self, other: InterfaceFlags) -> InterfaceFlags

Returns the set difference of the two sets of flags.

impl SubAssign<InterfaceFlags> for InterfaceFlags

fn sub_assign(&mut self, other: InterfaceFlags)

Disables all flags enabled in the set.

impl UpperHex for InterfaceFlags

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.